View All NSE7_SDW-7.0 Actual Free Exam Questions Nov 03, 2023 Updated
Pass Authentic Fortinet NSE7_SDW-7.0 with Free Practice Tests and Exam Dumps
Fortinet NSE7_SDW-7.0 certification exam is intended for IT professionals who work with Fortinet's SD-WAN solutions or are planning to do so. NSE7_SDW-7.0 exam covers a range of topics, including SD-WAN architecture, deployment scenarios, security policies, traffic management, and troubleshooting. NSE7_SDW-7.0 exam consists of multiple-choice questions and is administered through Pearson VUE.
Fortinet NSE7_SDW-7.0 Certification Exam covers a range of topics, including SD-WAN architecture and design, Fortinet SD-WAN products and solutions, WAN optimization, security, and management. NSE7_SDW-7.0 exam consists of 60 multiple-choice questions that must be completed within 120 minutes. To pass the exam, candidates must achieve a minimum score of 70%. Fortinet NSE 7 - SD-WAN 7.0 certification is useful for IT professionals who want to advance their careers in SD-WAN technologies and work with Fortinet solutions to design and implement SD-WAN solutions for their organizations.
NEW QUESTION # 36
Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)
- A. http
- B. twamp
- C. icmp
- D. dns
Answer: A,D
Explanation:
Pages 85,86 in Study guide 7.0 Pages 100,101 in Study guide 7
NEW QUESTION # 37
Refer to the exhibit.
Which statement about the role of the ADVPN device in handling traffic is true?
- A. Two hubs, 10.0.1.101 and 10.0.2.101, are receiving and forwarding queries between each other.
- B. This is a hub that has received a query from a spoke and has forwarded it to another spoke.
- C. Two spokes, 192.2.0.1 and 10.0.2.101, forward their queries to their hubs.
- D. This is a spoke that has received a query from a remote hub and has forwarded the response to its hub.
Answer: B
NEW QUESTION # 38
Refer to the exhibit.
Based on the exhibit, which two statements are correct about the health of the selected members? (Choose two.)
- A. FortiGate can offload the traffic that is subject to passive monitoring to hardware.
- B. After FortiGate switches to active mode, FortiGate never fails back to passive monitoring.
- C. During passive monitoring, FortiGate can't detect dead members.
- D. FortiGate passively monitors the member if TCP traffic is passing through the member.
Answer: C,D
NEW QUESTION # 39
Refer to the exhibit.
Which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules?
- A. All traffic from a source IP to a destination IP is sent to the least used interface.
- B. All traffic from a source IP is sent to the most used interface.
- C. All traffic from a source IP is sent to the same interface.
- D. All traffic from a source IP to a destination IP is sent to the same interface.
Answer: D
NEW QUESTION # 40 
Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)
- A. The traffic shaper drops packets if the bandwidth exceeds 6250 KBps.
- B. The traffic shaper drops packets if the bandwidth is less than 2500 KBps.
- C. The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps.
- D. The measured bandwidth is less than 100 KBps.
Answer: A,D
NEW QUESTION # 41
Which two statements about SD-WAN central management are true? (Choose two.)
- A. It supports normalized interfaces for SD-WAN member configuration.
- B. It does not support meta fields.
- C. The objects are saved in the ADOM common object database.
- D. It uses templates to configure SD-WAN on managed devices.
Answer: C,D
Explanation:
Explanation
Normalized interfaces are not supported for SD-WAN templates. You can create multiple SD-WAN zones and add interface members to the SD-WAN zones. You must bind the interface members by name to physical interfaces or VPN interfaces.https://docs.fortinet.com/document/fortigate/7.0.0/sd-wan-new-features/794804/new-sd-wan-template-
NEW QUESTION # 42
Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?
- A. get ipsec tunnel list
- B. diagnose vpn tunnel list
- C. diagnose debug application ike
- D. get router info routing-table all
Answer: C
NEW QUESTION # 43
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )
- A. An absolute SD-WAN rule was defined and matched traffic.
- B. Traffic has matched none of the FortiGate policy routes.
- C. The FIB lookup resolved interface was the SD-WAN interface.
- D. Matched traffic failed RPF and was caught by the rule.
Answer: B,C
NEW QUESTION # 44
Refer to the exhibit.
The exhibit shows the BGP configuration on the hub in a hub-and-spoke topology. The administrator wants BGP to advertise prefixes from spokes to other spokes over the IPsec overlays, including additional paths. However, when looking at the spoke routing table, the administrator does not see the prefixes from other spokes and the additional paths.
Based on the exhibit, which three settings must the administrator configure inside each BGP neighbor group so spokes can learn other spokes prefixes and their additional paths? (Choose three.)
- A. Set advertisement-interval to the number of additional paths to advertise
- B. Set additional-path to send
- C. Enable soft-reconfiguration
- D. Enable route-reflector-client
- E. Set adv-additional-path to the number of additional paths to advertise
Answer: B,D,E
NEW QUESTION # 45
Refer to the exhibit.
Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?
- A. type must be set to static.
- B. mode-cfg must be enabled.
- C. exchange-interface-ip must be enabled.
- D. add-route must be disabled.
Answer: D
Explanation:
for using "non ike" routes (for example BGP/static and so on) you must do disable the add-route that inject automatically kernel route based on p2 selectors from the remote site from the SD-WAN_7.2_Study_Guide page 236
NEW QUESTION # 46
Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Reverse-policy shaping mode
- B. Per-IP shaping mode
- C. Interface-based shaping mode
- D. Shared-policy shaping mode
Answer: C
Explanation:
Explanation
Interface-based shaping goes further, enabling traffic controls based on percentage of the interface bandwidth.
NEW QUESTION # 47
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )
- A. A total of six packets are exchanged between an initiator and a responder instead of three packets.
- B. XAuth is enabled as an additional level of authentication, which requires a username and password.
- C. A peer ID is included in the first packet from the initiator, along with suggested security policies.
- D. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.
Answer: A,B
NEW QUESTION # 48
Which two protocols in the IPsec suite are most used for authentication and encryption? (Choose two.)
- A. Internet Key Exchange (IKE)
- B. Secure Shell (SSH)
- C. Encapsulating Security Payload (ESP)
- D. Security Association (SA)
Answer: A,C
NEW QUESTION # 49
Refer to the exhibits.
Which two statements about the IPsec VPN configuration and the status of the IPsec VPN tunnel are true? (Choose two.)
- A. The phase 1 configuration supports the network-overlay setting.
- B. FortiGate facilitated the negotiation of the T_INET_1_0_0 ADVPN shortcut over T_INET_1_0.
- C. Dead peer detection is disabled.
- D. FortiGate does not install IPsec static routes for remote protected networks in the routing table.
Answer: A,D
NEW QUESTION # 50
Refer to the exhibit.
Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change? (Choose two.)
- A. FortiGate flushes all sessions.
- B. FortiGate evaluates new sessions.
- C. FortiGate does not change existing sessions.
- D. FortiGate terminates the old sessions.
Answer: B,C
Explanation:
FortiGate not to flag existing impacted session as dirty by setting firewall-session-dirty to check new. The results is that FortiGate evaluates only new session against the new firewall policy.
NEW QUESTION # 51
......
New NSE7_SDW-7.0 Exam Questions Real Fortinet Dumps: https://braindumps.exam4tests.com/NSE7_SDW-7.0-pdf-braindumps.html